Parts and materials needed:

Soldering Iron

10 mm wrench or socket for panel removal

Phillips Screwdriver

Flat Screwdriver


The car’s bottom protection is offered by the plastic under-panels which cover and protect important parts of the vehicle such as coolant, fuel and A/C lines, fuel filter, etc.


Road debris, age of vehicle and general road conditions greatly affects these panels causing breaks, rips and missing pieces.


Although the panels are relatively affordable ($100 - $200 each) many times repairs can be made that will make them last longer and protect their intended parts.










































Because these panels are exposed to road grime it’s best to clean them before repair.


Plug in a fine point soldering iron (25-50 watts).



















Hold the two sides of the crack together and with the tip of the soldering iron melt across the crack in stitch-like fashion.  This acts as a tack-weld and holds the crack together.







After you’ve done one side of the crack,

turn the panel ,over and repeat the

stitching on the other side.


Generally this is enough for longitudinal

cracks, and you can re-mount in place.
















                                                                                            Where the panel has missing pieces you can

                                                                                            repair using a similar piece of material cut

                                                                                            roughly to size and welded in the same way.

























You can use a small upholstery flat iron to

smooth out the “stitches” for a cleaner look.


Normally the panels are held in place with 10 mm

plastic nuts crewed into existing studs secured to

the bottom of the vehicle.


Sometimes these studs are missing so I use an

oversized stainless steel screw to hold the panel

in place.






















Happy Boxstering,

Pedro















REPair broken plastic protection under-panel
you did-it-Yourself
press here to go back to the DIY page../Site/DIY_Projects.html
Do-it-Yourself
technolab